How our touchscreen gloves work
Every winter in New York, you see the same small ritual at every crosswalk. A phone buzzes. Someone pulls off a glove with their teeth, taps out a reply, and pulls the glove back on with a cold hand. To understand why that happens, and how we stopped it, you have to start with the screen.
How a touchscreen sees you
Almost every smartphone uses a projected capacitive touchscreen. Beneath the glass is a fine grid of transparent electrodes, laid out in rows and columns. At every point where a row crosses a column, the electrodes form a tiny capacitor, holding a small electrical field. A controller chip scans that grid many times per second, measuring the capacitance at each crossing.
Your finger is conductive and connected to the much larger mass of your body. When it comes close to the glass, it draws away part of that electrical field, and the capacitance at the nearest crossings drops. The controller reads the change, calculates its center, and that is your touch. The screen doesn't feel pressure at all. It detects a change in an electrical field.
Why ordinary gloves fail
Wool, alpaca, nylon: nearly every yarn we knit with is an electrical insulator. A glove puts a layer of insulating fiber and trapped air between your skin and the glass. The distance alone weakens the effect, and without a conductive path, the change at the grid falls below what the controller recognizes as a touch. You can press as hard as you like. Nothing happens.
The yarn in our fingertips
Into the fingertips of our gloves, we knit Eletex II, a conductive fiber developed by Japan Eletex in Toyama. It is a modacrylic fiber impregnated with a copper compound. The conductive material is carried in the fiber itself rather than painted onto its surface, which is why the maker rates it to hold its performance through more than 100 washes. It also dissipates static, and the copper compound gives it antibacterial and odor-resistant properties.
In the glove, it works as a bridge. The yarn touches your skin on the inside, reaches the glass on the outside, and extends your finger's conductivity through the knit. To the screen, the fingertip of the glove behaves like the fingertip of your hand.
Where the craft comes in
As with everything we make, the yarn is only half of it. For the bridge to work, the conductive yarn has to be present on both faces of the knit — against the skin and against the glass — with no break in between. It has to sit exactly in the zone of the fingertip that meets the screen. And the stitch has to be dense enough to put real contact area against the glass, but not so dense that the fingertip loses its softness.
Fit matters too. A loose fingertip leaves a gap of air between your skin and the yarn, and air is an insulator. That's one more reason we spend so much time on the shape of the fingers.